-40%

PADT Phoenix SCA-1200 3D Printer Support Cleaning Apparatus Stratasys SST Washer

$ 337.92

Availability: 67 in stock
  • Compatible Brand: For Stratasys
  • Compatible Model: For Stratasys 3D printers using SST
  • Brand: Phoenix Design and Analysis Technologies (PDAT)
  • MPN: SCA-1200
  • Type: Support Cleaning Apparatus
  • Model: SCA-1200 Support Cleaning Apparatus
  • Custom Bundle: No
  • Condition: Used
  • Country/Region of Manufacture: United States

    Description

    Excess from Stratasys's R&D department.  We are business equipment liquidators.
    The SCA-1200HT dissolves support from Stratasys 3D models created on any of the Stratasys 3D printers that use Soluble Support Technology (SST).
    Brand: Phoenix Design and Analysis Technologies (PDAT)
    Model: Support Cleaning Apparatus
    Model #: SCA-1200
    Serial #: 110-01604
    DOM: probably in the 2008-2014 range
    Testing overview:  Everything seems to work except the "water OVER level sensor"
    Testing detail: Filled water to below "MIN" water level marking.  Turned on. Pushed "SET" button.  Machine correctly indicated water level too low by turning on "LOW" level light on left edge (photo #2).  Turned off unit, filled water to above MIN and below MAX markings and then pushed "SET" once again.  Unit now shows low level light correctly off (photo #3).   Turned unit off and filled water to near very top of unit.  Turned on and pushed set once again.  Unit for some reason unit didn't turn on the "HIGH" level light (photo #4). Unsure if that is a stuck switch or broken or what.  Turned off unit, and drained water out rear drain valve to get it back to proper water height level.  Turned unit back on, pushed SET" once again.  The water mover moved the water around using its propulsion system in the front (photo #5) (kind of hard to tell from photo but it is moving good).  I let it sit that way for about 10 minutes to test the temp sensor.  It went up to 29C. (photo #6).  It would have gone a few degrees higher but at first I didn't think to put the lid on to keep the heat in so it probably didn't hold the heat when the lid was off.
    It seems to work as intended but does have the unknown reason why the water "OVER" sensor doesn't come one when the water is too high.  You decide if that makes a difference to you.  Lot includes the back drain hose (photo #9) and the internal basket "holder" (photo #10) but does not include either the large or small inner baskets.
    Note: Let me know if you want more than one as I can get up to two more.  I would test them too and then change photos and price to reflect the adjusted listing.
    It is too big for "Ground" shipping.  Estimated freight price is 0-0 depending on distance from Minneapolis, MN 55439.  Note: If listing changed to accomodate 2 or 3 units, shipping would probably go up very small amount since the pallet would be about the same dimensions and the weight would go from very light to still being lightweight.